MOSA GE 225 FSX (STAGE 3A) DIESEL GENERATOR
Call Now For Best Prices 01276 505012
The Mosa GE 225 FSX (Stage 3A) is a diesel powered generator run by a quality, water cooled FPT (IVECO) C87 TE1F engine, capable of 225 kVA three phase power generation.
The Mosa GE 225 FSX is a super silenced diesel generating set with a common rail engine with an electronic governor and a closed crankcase ventilation. The machine construction incorporates an integral roll bar, two central lifting points, forklift pockets and rear canopy section that is hinged to provide full access to the engine for maintenance. The 425 litre fuel tank provides a running time of 11.5 hours at a weight of 3220kg.
A bunded base must ensure the containment of fluids in the engine and fuel tank in the event of any loss, to prevent their dispersion in the environment.
AVR (Automatic Voltage Regulator) control ensures very stable power for equipment including sensitive electronics, computers, power tools etc. The recessed control panel houses the sockets and machine controls including circuit breaker and engine protection device.
EAS models are pre-wired to accept the optional MOSA EAS Automatic Start-Up Panel which plugs into the front panel of the Generator and enables the machine to be used as an emergency standby power unit in the event of power failure from the mains supply.
Also available is an optional TCM remote control allowing start/stop of the engine up to 10 metres distance from the machine.
Suitable for a wide range of uses including industrial sites, residential, construction, noise sensitive environments and emergency standby power.
In according with CE regulation
FACTORY INSTALLATION OPTIONS: Water Heater, Radio Control, Main Battery Switch, 3-way Valve Fuel System with quick connection for external fuel supply, Electronic Leakage Relay, Permanent Magnet, V adjustable from control panel, Automatic Fuel Transfer Pump, Low level water radiator sensor, Electrical panel with the following sockets: 1 x 400V 125A – 1 X 400V 32A – 2 X 230V 16A – 1 X 400V 63A and 1 X 400V 16A
EXTRAS ON REQUEST: Remote Control, Emergency Automatic Transfer Unit, Cyclone air pre-filter
The Automatic Voltage Regulator (AVR) is an electronic device that regulates the voltage level at all times to maintain precise AC output from the generating set. The AVR calculates how much voltage has to be sent to the exciter numerous times a second, therefore stabilising the output voltage to a predetermined set point.
The control characteristics of an AVR system are much more accurate than those of self-regulated alternators.
- Engine protection EP6
- Automatic voltage regulator “AVR”
- Common-rail engines with electronic governor
- Closed crankcase ventilation
- Four pole circuit breaker
- Oil drain pump
- Bunded base with drain plug
- Two central lifting eyes
- Ready for connection to automatic transfer unit EAS
- IP protection degree: 44
- Dimension: 3750x1400x2030 mm
- Dry weight : 3220 kg (FPT (IVECO) C87 TE1F)
- Measured acoustic power LwA (pressure LpA): 95 dB(A) (70 dB(A) @ 7m) (FPT (IVECO) C87 TE1F)
- Guaranteed acoustic power LwA (pressure LpA): 96 dB(A) (71 dB(A) @ 7m) (FPT (IVECO) C87 TE1F)
|Model||Fuel||Starter||Output Stand By||Output PRP||Cylinders / Displacement||Speed||Cooled|
|FPT (IVECO) C87 TE1F||Diesel||Eletric||195 kW (265.7 HP)||177 kW (240.7 HP)||6/ 8700 cm³||1500 rpm||Water|
|FPT (IVECO) NEF67 TE2A||Diesel||Electric||193 kW (262.5 HP)||175 kW (238 HP)||6/ 6700 cm³||1500 rpm||Water|